Toyota Camry (2007-Present) Bumper Removal DIY




Bumper Removal DIY Tutorial for a 6th Generation Camry (2007-Present)

Source: ToyotaNation

I know there are already a few similar threads on removing the bumper, but one more won’t hurt. 

I needed to replace my fog light bulbs, and I wanted to do a bit of tidying up as well as install my siren behind the bumper, so I thought I would make a DIY guide as I went along. I took photos of most of the install, however I couldn’t get good photos of removing the panels underneath, but it’s pretty straight forward on how to do that, and that should be done first.

*Note* All the Camry models have the plastic splash shield below the engine bay, that needs to be removed prior to removing the bumper. However I removed mine earlier as it was damaged during the winter, which is why you can’t see it.

Now, before you start make note of how everything is setup, so you will have a good idea on how it should be put back together. There are 3 screws and several clips that need to be removed from the engine bay area.

This image has been resized. Click this bar to view the full image.

Now remove the clips by pushing down in the middle, and remove the three screws that are holding the top of the bumper together.

This image has been resized. Click this bar to view the full image.

This image has been resized. Click this bar to view the full image.

Now theres a screw hidden behind the wheel well, however before getting to that you need to remove the plastic shield from beneath the car (If you haven’t already done so). Then you need to pry back on the wheel well shield until the plastic is removed like so:

This image has been resized. Click this bar to view the full image.

This image has been resized. Click this bar to view the full image.

The next step is to remove the screw/bolt from behind the wheel well:

This image has been resized. Click this bar to view the full image.

Once the screws are removed, you can pry back carefully until it becomes unhooked from the clips like so:

This image has been resized. Click this bar to view the full image.

This image has been resized. Click this bar to view the full image.

This image has been resized. Click this bar to view the full image.

Now you should be able to lift up on the bumper and pull it off:

This image has been resized. Click this bar to view the full image.

Now the bumper should be off and there shouldnt be anything connected to it unless you have fog lights installed:

This image has been resized. Click this bar to view the full image.





View More Toyota Camry DIY's

You can leave a response, or trackback from your own site.

2 Responses to “Toyota Camry (2007-Present) Bumper Removal DIY”

  1. Rich says:

    I have to remove the REAR bumper cover on my ’09 Camry, and have a question about the clips where the bumper cover and rear quarter panel meet. Do you just pull away the rear bumper cover after removing appropriate screws and plastic mounts?
    The holes appear to be horizontal with the body – does the cover just snap back together?
    I can’t seem to find a clear picture of the clips.
    Should I buy replacement clips for the attaching points along the rear quarter before removing the cover in the event any break?
    Thanks for your help!,
    Rich

  2. shayla says:

    Hi did you fix your rear bumper? My tire exploded and my rear bumper came off on the left hand side. Now, I want to remove it and put a factory rear bumper on. I am a “girl” and was wondering is it hard to do or can anyone do it?

Leave a Reply to shayla

Powered by WordPress